• Highlights
  • Specifications
  • Accessories
  1. SAS to SAS RAID subsystem
  2. Redundant or single RAID controller
  3. EonPath® multi-pathing, load-balancing software
  4. 4 or 2 SAS 4x wide host ports
  5. Hardware RAID6 engine by dedicated ASIC400 chipsets
  6. Superior performance w/ uncomplicated connectivity
  7. 16 SAS disk drives
  8. Expansion to 80TB via a 4x wide expansion port
  9. Corresponding JBODs: S16S-J1000-R (dual-controller); S16S-J1000-S (single-controller)
Model Host Interface Drive Interface Controller Form Factor
S16S-G1030 2 multi-lane wide ports (SFF-8470) SAS Single 3U rack-mount
Corresponding JBODs
  1. Hardware RAID parity computing
RAID JBOD Max. number
S16S-G1030 S16S-J1000-S 4

Information about supported disk drives, network components, and software compatibility, please refer to our VIPRoom website (for authorized dealers).

RAID
  1. Hardware RAID5 & RAID6
  2. Supports RAID 0, 1 (0+1), 3, 5, 6, 10, 30, 50, 60, NRAID
  3. RAID Migration
  4. Configurable stripe size and write policy per array
  5. Multiple Global, Dedicated, & Enclosure-specific hot-spares
  6. Intelligent Drive Handling:
    1. In degraded mode: skips irreparable blocks to continue rebuild
    2. In normal operation: data-block verification and repair
Host Interface
  1. 4 (S16S-R1030) or 2 (S16S-G1030) SAS wide ports
  2. 12Gbps bandwidth (half duplex) per port
  3. Concurrent I/O commands
  4. Tagged command queuing up to 1024
  5. Max. command queue up to 1024
  6. Fault-tolerant host links with the EonPath multi-pathing software

Drive Interface

  1. 16 3.0Gbps SAS, hot-swappable drive trays
  2. Accommodates 1-inch pitch, 3.5-inch SAS disk drives
  3. S.M.A.R.T. and NCQ support
  4. Automatic bad-sector reassignment
  5. Dedicated bandwidth to each connected drive
  6. In-band enclosure service through the expansion links from expansion enclosures
  7. Path redundancy to disk drives via edge expanders and expanders on JBOD controllers through separate SAS domains
  8. MUX kits with port selectors for dual-controller access to SATA drives
System Components
  1. High density, smartly managed 3U enclosure
  2. Dual redundant or single RAID controller
  3. One DIMM module with capacities from 512MB to 2GB
  4. Redundant, hot-swappable 530W power supply units
  5. Redundant, dual-speed cooling modules 
  6. Sixteen (16), hot-swappable drive trays
  7. Two (2) forearm handles
  8. Li-Ion battery backup unit (BBU), life expectancy and charge level aware
Management
  1. COM1 serial port for local access to firmware-embedded utility
  2. COM2 for UPS connection
  3. Automated cache flush and caching mode operation per enclosure status
  4. GUI, Telnet, and SSH system monitoring via Ethernet
  5. Java-based SANWatch software
  6. Firmware-embedded manager via RS-232C (audio jack) that is platform independent
  7. Widest range of event notification methods including email, LAN broadcast, fax, SNMP traps, SMS, and MSN
  8. LCD keypad panel for monitoring and access to all configuration options
  9. Variable logical drive options per DIMM size
  10. Module status LED indicators:
    1. Two (2) per drive tray
    2. Seven (7) per controller module
    3. One (1) per power supply unit
    4. One (1) per BBU module
    5. Two (2) per cooling module
  1. Presence detection & thermal sensors via I2C bus
Power Supply Module

Redundant hot-swappable power supplies with PFC

Input 100VAC at 9A, 240VAC at 4.5A with PFC (auto-switching)
47 to 63Hz
Output (Maximum output: 530 Watts)
+12.0V 32A max.
+ 5.0V 32A max.
+3.3V 30A max.
Cooling Module

Redundant dual-thermal-fan cooling modules

Maximum air flow 90CFM (high speed);
70.7CFM (low speed)
Environmental Specifications
Operating temperature: 5º to 40ºC  (35°C if battery is applied)
Non-operating temperature: - 40º to 60ºC
Relative humidity: 5 to 95%, non-condensing
Operating altitude: Operating: 0 to 12,000 ft
Dimensions
  1. Package: 423(H) x 567(W) x 772(D) mm (16.7 x 22.3 x 30.4 inches)
System Weight
  1. Net weight: 28.5kg (62.7 pounds)
  2. Gross weight: 30.5kg (67.1 pounds)

Spare Parts

IFT-83S10RE16 SAS to SAS RAID controller module, for dual-controller configuration, 4 x multi-lane SAS host ports + 1 SAS expansion port, RAID 6
IFT-83S10GE16 SAS to SAS RAID controller module, for single-controller configuration, 4 x multi-lane SAS host ports + 1 SAS expansion port, RAID 6
IFT-9373CDTray (G1030) 3.5" Hard disk drive tray
IFT-9373S1DT2S1S (R1030) 3.5" Hard disk drive tray w/MUX board, exclusively for dual-controller subsystems v1.2
IFT-9270CHandR Right-side forearm handle for EonStor 3U series subsystems
IFT-9273CHandLLCD Left-side forearm handle for EonStor 3U series subsystems, LCD panel included
IFT-9273ECPSU Power supply module for EonStor 3U series, ASIC400 series subsystems, 530W capacity
IFT-9273ECFanMod Cooling fan module for EonStor, ASIC400, and 3U-profile series subsystems
IFT-9270CmSASCab4 SAS external cable, MiniSAS 4X(SFF-8088) to Infiniband 4X(SFF-8470, thumbscrew type), 120 Centimeters
IFT-DDRESCEM5 512MB DDR RAM DIMM module
IFT-9011 Null modem, DB9 female to DB9 male, wires swapped
IFT-9270ASCab (G1030) Serial port cable for single-controller subsystems, 1 audio jack -to- 1 DB-9
IFT-9270AYCab (R1030) Serial port cable for dual-controller subsystems, 2 audio jacks -to- 1 DB-9 Y-cable

Accessories

IFT-9270CmSASCab3 SAS external cable, MiniSAS 4X(SFF-8088) to Infiniband 4X(SFF-8470, thumbscrew type), 50 Centimeters
IFT-9273CBTE Battery cell pack, Li-Ion, 4-cell for EonStor ASIC400, 3U-profile series
IFT-9270CUPSCab Serial port cable to UPS device for single-controller subsystems, 1 audio jack -to- 1 DB-9
IFT-9270CUPSYCab Serial port cable to UPS device for dual-controller subsystems, 2 audio jacks -to- 1 DB-9 Y-cable
IFT-9273CSlider32 Slide rail assembly, for Enhanced ES 3U/16-bay subsystem, 23"~32" rack depth
IFT-9270CSASCab01 SAS external cable, SFF-8470 to SFF-8470, thumbscrew type, 50 Centimeters
IFT-9270CSASCab02 SAS external cable, SFF-8470 to SFF-8470, thumbscrew type, 120 Centimeters
IFT-9273CSlider36 Slide rail assembly, for Enhanced ES 3U/16-bay subsystem, 23"~36" rack depth
IFT-DDRESCEMA 1GB DDR RAM DIMM module
9273S1N2S1S IFT-9273S1N2S1S MUX board, 3.5" HDD, exclusive for SAS 3G drive side dual-controller subsystems, 5V only, Rev. 1.2